10 pre drilled distributors 1/25 scale

Here it is, by popular request, the pre drilled distributors I use for all my builds... set of 10. what you need for wires! as shown in the picture, I use wrapping wire 30awg from amazon. available in several colors. this is perfect for higher performance wires. ie 8 or 9mm wires. want a more stock or factory 7mm wire? use either .3mm solder (also on amazon, hard to find local) then paint. or an equally fine wire. if you use the 30 gauge, simply strip a small part o the end to expose the inner copper, then trim to just a small point. light dip in super glue (cement does not work on resin) patiently put each in and wait 30 seconds or so, then voila. you have wired distributors for pennies no more trying to drill out kit dists that look like pop ooh. also, I can tell you, its easier to do without scotch. New and improved printing!!! Cleaner and more detailed than ever. About resin parts Resin can be fragile, it can also be susceptible to extreme temperatures. Pieces are unpainted and in raw form. You can prime and or paint. You can also sand if needed. Some items may need customizing or fitting depending on your needs. There is a slight tackiness or uncured resin on my part? This is rare, but can happen. Don’t panic… if you have some isopropyl alcohol, use this to clean up anything, then place in sunlight for a few minutes. Need something else printed? Feel free to reach out. I have almost anything you need